ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||15 April 2007|
|PDF File Size:||20.75 Mb|
|ePub File Size:||11.92 Mb|
|Price:||Free* [*Free Regsitration Required]|
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur. AlloyAlloy Brand: Siddhagiri Metals and Tubes Rating: Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile and compressive conditions, without altering the sheet thickness.
Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost. Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes asfm in a part.
Nickel 200® & Nickel 201®
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. This abstract is a brief summary of the referenced standard.
These sheets are made by rolling process. Siddhagiri Metals and Tubes Manufacturer: Link to Active This link will always route to the current Active version of the standard.
ASTM B – 99 Standard Specification for Nickel Plate, Sheet, and Strip
Offer on Fasteners Sitemap. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
The material shall conform to the b1622 property requirements for tensile strength, yield strength, elongation, and Rockwell hardness. Looking for some more information?
The material shall be uniform in quality and b612, smooth, commercially straight or flat, and free of injurious imperfections. Test methods chemical analysis, mechanical test, grain size test shall be performed in accordance to referenced ASTM documents itemized herein.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the elimination of the anneal that follows hot rolling. For deep drawing and spinning quality sheet and strip, the material shall conform to specified bb162 for grain size and hardness properties.
Historical Version s – view previous versions of standard. Sheet and Strip can be cold rolled to higher strength.