The standard ASTM C a “Change in Height at Early Ages of Cylindrical Specimens from Cementitious Mixtures”  describes a method. ASTM C Standard Test Method for Change in Height at Early Ages of Cylindrical Specimens from Cementitious Mixtures. Lab ID: Use This test is used. ASTM A/AM Steel, Sheet and Strip, Heavy-Thickness Coils, Hot- Rolled, Carbon, Commercial, Drawing, Structural, High-Strength Low-Alloy.
|Published (Last):||23 October 2013|
|PDF File Size:||2.16 Mb|
|ePub File Size:||14.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
Print and complete the following order form. MSDS must accompany all samples submitted. These include shrinkage or expansion due to hydration, settlement, evaporation, and other physical and chemical effects.
Contact Mike Morrison for additional information. It would be appropriate to use this test method as a basis for prescribing mixtures having restricted or specified volume change before the mixture becomes hard. Use This test is used to determine the change in height of a 3×6-in cylinder from the time of casting until asgm set is reached.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Time for Results Please d827 a CTLGroup chemical services representative or Project Manager to discuss your individual project needs and testing response times. Combining values from the two systems may result in non-conformance with the standard. However, the specimen used in this test method is not completely unrestrained so that the measurements are primarily useful for comparative purposes rather than as absolute values.
ASTM C827/C827M – 16
Qstm maximum change in height will be reported, maximum decrease, maximum increase, change in height at set time and change in height at conclusion of test. If you need more info or have any questions, please note the Lab ID number and contact us at:.
Instructions Submit all necessary materials to perform test including mixing instructions, mix design. It is particularly applicable to grouting, patching, and form-filling operations where the objective is to completely fill a cavity or other defined space with a freshly mixed cementitious mixture that will continue to fill the same space at time of hardening.
Results Produced All height change measurements will be reported as percent change over time. If you need more info or have any questions, please note the Lab ID number and contact us at: The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
ASTM C Height Change at Early Ages of Cementitious Mixtures | CTL
Link to Active This link will always route to the current Active version of the standard. Further, the degree of restraint to which the specimen is subjected varies with the viscosity and degree of hardening of the mixture. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
C87 notes and footnotes shall not be considered as requirements of the test method.